Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 153)

IPv6 Addressing Commands
Page 153
show ipv6 route
The show ipv6 route command displays the current state of the ipv6 routing table.
Syntax
show ipv6 route
Default Configuration
This command has no default setting.
Command Mode
EXEC mode
Examples
The following example displays the state of the IPv6 Routing Table.
ipv6 nd dad attempts
The ipv6 nd dad attempts Interface Configuration mode command configures the number of consecutive
neighbor solicitation messages that are sent on an interface while duplicate address detection is performed on the
--------------- ---------- ----------
FE80::4 Link Local Duplicated
2031:0:130F:0:0:9C0:876A:130D/64 Static Active
console# show ipv6 interface Vlan 17
Ipv6 is enabled
Number of ND DAD attempts: 20
IP addresses Type DAD State
--------------- ---------- ----------
FE80::9C0:876A:130D Link Local Active
2031:0:130F:0:0:9C0:876A:130D/64 Static Active
Console> show ipv6 route
Codes: L - Local, S - Static, I - ICMP, ND - Router Advertisment
The number in the brackets is the metric.
S ::/0 via fe80::77 [0] VLAN 1 Lifetime Infinite
ND ::/0 via fe80::200:cff:fe4a:dfa8 [0] VLAN 1 Lifetime 1784 sec
L 2001::/64 is directly connected, g2 Lifetime Infinite
L 2002:1:1:1::/64 is directly connected, VLAN 1 Lifetime 2147467 sec
L 3001::/64 is directly connected, VLAN 1 Lifetime Infinite
L 4004::/64 is directly connected, VLAN 1 Lifetime Infinite
L 6001::/64 is directly connected, g2 Lifetime Infinite