Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 326)

Page 326
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
Example
This example changes Unit Number 6 to Unit Number 5. The command takes effect only after resetting the device.
show stack
The show stack User EXEC mode command displays information about the status of a stack.
Syntax
show stack [unit unit]
Parameters
•
unit — Specifies the number of the unit. (Range: 1 - 6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command is not relevant to standalone devices.
Example
The following example displays stack status..
console# config
console(config)# stack change unit-id 6 to 5
Console> show stack
Unit MAC Address Software Master Uplink Downlink Status
---- ----------------- -------- -------- ------ -------- ------
1 00:15:77:74:64:40 v1.1.0.23 Enabled 2 3 Master
2 00:15:77:66:3e:80 v1.1.0.23 Enabled 3 1 Backup
3 00:01:02:03:04:05 v1.1.0.23 Disabled 1 2 Slave
Topology is Ring
Unit Unit Id After Reset
---- -------------
1 1
2 2
3 3