Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 348)

Page 348
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
switchport mode
The switchport mode Interface Configuration mode command configures the VLAN membership mode of a port.
Use the no form of this command to return to the default configuration.
Syntax
switchport mode {access | trunk | general}
no switchport mode
Parameters
•
access — Indicates an untagged layer 2 VLAN port.
• trunk — Indicates a trunking layer 2 VLAN port.
• general — Indicates a full 802-1q supported VLAN port.
Default Configuration
All ports are in access mode, and belong to the default VLAN (whose VID=1).
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines.
Example
The following example configures Ethernet port 1/g16 as an untagged layer 2 VLAN port.
console(config)# interface ethernet 1/g16
console(config-if)# switchport mode access