Goulds Pumps IC - IOM - Manual (Page 63)

922
2. Loosen and remove the hexagon bolts (901.41) that hold the frame adapter to the bearing frame.
3. Remove the frame adapter (344) from the bearing frame (330).
923.51
302.52
932.51
330
320.51
344
4. Reach inside the frame and remove the snap ring (932.51) using the designated snap ring pliers.
Use snap ring pliers according to DIN 5256-C. Refer to this table for the correct size:
Bearing frame size Pliers size Minimum length of pliers
24 94/C 40 8 in. (200 mm)
32, 42 94/C 85 10 in. (250 mm)
48 94/C 85 12 in. (300 mm)
5. Remove the shaft (210), with the radial and thrust bearings (320.51 and 320.52) and the bearing nut
(923.51) attached, from the bearing frame (330).
Maintenance
Model IC, ICI, ICH, ICIH Installation, Operation, and Maintenance Manual 61