Goulds Pumps IC - IOM User Manual
Page 72
302.52
932.51
f) As a recommendation, thread a stud into one of the four threaded bolt holes in the frame adapter
(344), and finger tighten only.
The stud must be between 40 and 50 mm in length. This helps you to align the adapter bolt holes
to the frame bolt holes during assembly.
g) Slide the properly heated radial bearing (320.51) onto the shaft.
The bearing slides easily into place against the shoulder on the shaft
h) Place the frame adapter (344) over the radial bearing. Allow the radial bearing to cool for at least
10 minutes.
i) When bearing is cool, gently tap the frame adapter until the radial bearing is properly seated in the
frame adapter. Make sure that the bolt holes are aligned.
923.51
302.52
932.51
330
320.51
344
Maintenance
70
Model IC, ICI, ICH, ICIH Installation, Operation, and Maintenance Manual