Seal chamber and stuffing box cover inspection – Goulds Pumps IC - IOM User Manual
Page 69
Advertising
Figure 13: Inside and outside inspection locations
Seal chamber and stuffing box cover inspection
Checklist
Perform these checks when you inspect the seal chamber and stuffing box cover:
• Make sure that these surfaces are clean:
• Seal chamber and stuffing box cover
• Mounting
• Make sure there is no pitting or wear greater than 1/8 in. (3.2 mm) deep.
Replace the seal chamber and stuffing box cover if pitting or wear exceeds this measurement.
• Inspect the machined surfaces and mating faces noted in the figures.
These images point to the areas to inspect:
Figure 14: Seal chamber
Maintenance
Model IC, ICI, ICH, ICIH Installation, Operation, and Maintenance Manual
67
Advertising