RADWAG MA 200.3Y Moisture Analyzer - Manual (Page 9)

- 9 -
2.2. Safety information
CAUTION!
The use of moisture analyzer MA 3Y regardless of both, safety
information and user manual guidelines may cause health damage
and even death
WARNING:
Nominal voltage for a moisture analyzer is 230 VAC. It means
that safety usage precautions for low voltage devices must be
abide by while operating the device.
Three-core power supply cable with grounding pin comes
standard with a moisture analyzer.
If necessary, an extension cord can be used as long as it meets
the applicable standards and has a protective ground conductor.
Intended disconnection of the grounding cable is forbidden.
CAUTION:
Drying chamber cannot be opened during operation (drying
process). It is due to the fact that a halogen lamp and its glass
shield may reach the temperature of up to 400 C.
When setting up the moisture analyzer leave enough space to
prevent heat from building up and to keep your analyzer from
overheating. Leave about 20 cm around the instrument and
about 1 m above.
Air vents that are located in the housing cannot be covered,
sealed or blocked in any other way.
Do not put any flammable substances on, under or near the
moisture analyzer.
Be particularly careful when removing the sample from the
drying chamber: the sample itself, the drying chamber, shields
and the pan can still be extremely hot.
In case of any maintenance work (cleaning the inside of the
drying chamber), the moisture analyzer must be switched off.
Wait until all the components have cooled down. Do not perform
any modification to the heating module.
Same types of samples require taking particular safety
precautions.
They can pose a danger for people and objects. It is always the user
who is liable for possible damages caused by the use of an
inappropriate sample.
CAUTION: