Konica Minolta bizhub 161f - Manual (Page 258)

8.10 When Incorrect Copies Are Produced 8
bizhub 161f 8-29
W
hen
a M
e
s
s
a
ge A
p
p
ear
s
Ch
apte
r 8
The printed output has dark specks
or spots.
The printed output has lines.
The Original Glass surface is
dirty. Wipe the Original Glass clean
with a soft, dry cloth.
The Original Pad is dirty. Wipe the Original Pad clean
with a soft cloth dampened with
neutral detergent.
The original is highly
transparent. Place a blank sheet of paper
over the original.
The original is 2-sided. If a thin double-sided document
is being printed, the information
on the back side may be
reproduced in the print. Press
the [ ] key and select a lighter
print density.
Something is sticking to the
Original Glass (when the
Automatic Document Feeder is
used). Wipe the Original Glass clean
with a soft, dry cloth.
The Drum Cartridge has
reached the end of its service
life. Contact your service
representative.
The printed output on the copy is not
aligned properly. The original is not placed in the
correct position. Place the original correctly on
the Original Glass against the
Original Scales.
Or, load it in the Automatic
Document Feeder correctly
along the Document Guide
Plates.
The original may not be
suitable for use in the
Automatic Document Feeder. Raise the Automatic Document
Feeder and place the original
on the Original Glass correctly
against the Original Scales.
The paper guides are not
pressed up against the paper
stack in the tray. Slide the paper guides against
the edges of the paper stack.
The paper has an excessive
curl. Smooth out curls in the paper
and reload the paper stack in
the tray.
The printed page is curled. The paper that was used curls
easily (as with recycled paper). Remove the paper from the
paper tray, turn it over, and
then load it again.
Change the paper.
Symptom Possible Cause Action
Ц