2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 35)

Table of Parameters 3.2
35
Replace character + in CLI by Function No.: 149
If this parameter is filled, the + character in the international prefix of CLI is
replaced by the defined string. The + character can neither be transmitted by
the FSK protocol nor dialed by the DTMF from a terminal.
Setting options: 0-4 characters (0-9,*,#)
Default setting: blank
„BabyCall“ – Automatic call
BabyCall number Function No.: 180
A number to be dialed for the automatic call function. If this item is blank, the
function is disabled.
Setting options: 0-20 characters (0-9,*,#,+)
Default setting: blank
BabyCall timeout [s] Function No.: 181
Time between line Off-Hook and automatic call beginning (if enabled). During
this timeout 2N® SmartGate waits for dialing that cancels the automatic call.
You can make standard call if the BabyCall function is enabled.
Setting options: 0-255 s
Setting step: 1 s
Default setting: 0 s
Telephone interface FXO parameters
Dialing parameters
Number of rings before Off-Hook Function No.: 200
If 2N® SmartGate is programmed as FXO gateway, parameter sets the count of
rings before Off-Hook.
Setting options: 1-255
Step: 1
Default setting: 1
Time for dialing start Function No.: 202
If 2N® SmartGate is programmed as FXO gateway, parameter defines timeout
for first dialing digit. After timeout 2N® SmartGate hangs up the line.
Setting options: 1-255 s
Step: 1 s
Default setting: 15 s