2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 45)

Table of Parameters 3.2
45
Setting options: 0-16 characters (0-9,*,#)
Default setting: blank
Call enable Function No.: 491
This parameter allows/bars calls with corresponding prefixes.
Setting options: YES(1)/NO(0)
Default setting: YES
Number length Function No.: 493
The parameter defines the expected length of dialed number. It enables to start
dialing into GSM or FXO interface immediately after the last digit is dialed. If the
telephone number to be dialed is shorter, a timeout is respected. The "0" setting
means that the function is disabled.
Setting options: 0, 3-15
Setting step: 1
Default setting: 0
End with # Function No.: 494
This parameter enables to establish the call when a # is received. The #
character is removed from the dialed number. If a # should be part of the dialed
number, this function cannot be used for the given prefix.
Setting options: YES(1)/NO(0)
Default setting: NO
Remove FunctionNo.: 495
The Remove parameter is used for automatic call routing. A defined count of
digits (prefix) is removed from the number beginning.
Setting options: 0-20
Setting step: 1
Default setting: 0
Add Function No.: 496
The Add parameter is used for automatic call routing. A defined string (prefix) is
added to the beginning of the number to be dialed.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
Time limit [min] Function No.: 499
After time elapsing is call connection terminated immediately. You can hear beep
30s before end of call. 10s before end you can hear beep every second. The "0"
setting means that the function is disabled.
Setting options: 0-255 min
Setting step: 1 min
Default setting: 0 min