2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 49)

Table of Parameters 3.2
49
Send if activated longer than [ms] Function No.: 601
Set the SMS activation time necessary for SMS sending. This parameter prevents
SMS sending in the event of short-time activation. If a "0" is selected, SMS is
sent immediately upon the input activation.
Setting options: 0-25500 ms
Setting step: 100 ms
Default setting: 0 ms
Timeout after sending [s] Function No.: 602
Set the Time of inactivity after SMS sending. During this timeout no SMS is sent
even if the SMS input gets activated. This prevents sending multiple SMS units in
the case of repeated activation of the input.
Setting options: 0-2550 s
Setting step: 10 s
Default setting: 0 s
GSM & SIM Parameters
Blocked for operator Function No.: -
Provider blocking is set by manufacturer in SmartGate. If 2N® SmartGate is
blocked to a GSM provider, no other GSM provider's SIM card can be used. If an
unacceptable SIM card is used, the GSM module does not register to GSM and
the GSM network LED flashes quickly on the 2N® SmartGate panel.
CLIR - incognito Function No.: 701
Sets the calling line identification restriction (CLIR) for outgoing calls from
SmartGate. Attention, before enabling it is necessary to activate this feature by
GSM operator, otherwise outgoing calls can be rejected by GSM network.
Setting options: -According to provider (0) - depending on how the
function is selected in the GSM network
-Activation (1) - ID is not sent.
-Suppression (2) - ID is always sent.
Default setting: According to provider
Roaming enable/disable Function No.: 702
You can make 2N® SmartGate work even if it is registered to a foreign GSM
network.
Setting options: -Disable (0) -The GSM module logs out of a foreign
network and attempts to register again in within 5
minutes.
-Enable (1) - 2N® SmartGate works in any GSM
network.
Default setting: Disable