2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 44)

Table of Parameters 3.2
44
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
Mobility Extension - number of rings Function No.: 402
If you program 2N® SmartGate as DialThru gateway and ME number is filled in,
2N® SmartGate starts to establish GSM call to ME number after defined number
of rings. Then you can receive incoming FXO call on telephone line or in GSM
network.
Setting options: 0-255
Step: 1
Default setting: 1
Mobility Extension - password for activation / disabling
Function No.: 403
If you program 2N® SmartGate as DialThru gateway and fill in ME number,
function ME is active. If you fill in password for ME activation/disabling, you can
activate/disable function ME without PC programming.
Off-Hook FXS line and dial PASSWORD plus to disable the function.
Off-Hook FXS line and dial PASSWORD plus to activate the function again.
Setting options: 0-8 characters (0-9)
Default setting: blank
Operator for Integra Function No.: 405
In some GSM networks you can add to dialed number # character and PBX
subscriber number. Subscriber number is displayed on other side together with
CLI. This parameter take place when dialed number doesn't contain # character.
Common parameter for both FXO and FXS port.
Setting options: 0-8 characters (0-9)
Default setting: blank
DTMF code for On-Hook Function No.: 409
Using this code, you can terminate call to GSM network, if busy tone detection
on 2N® SmartGate fails, or if connected equipment doesn't transmit busy
tone.
Setting options: 0-8 characters (0-9,*,#)
Default setting: blank
Caution
 Configuration using phone line programming (DTMF) is applicable for line
„Other prefixes‟ only.
Prefix Function No.: -
Dialed number prefix identifying the call type. "Other numbers" line is used for
calls with prefixes that are not included in the table.