2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 51)

Table of Parameters 3.2
51
Setting options: - Enable
- Disable
Default setting: Disable
Call transfer service prefix Function No.: -
Fill in relevant service code. For help see call transfer in virtual GSM PBX
description.
Setting options: 0-8 character
Default setting: blank
Time period for low credit checking [h]Function No.: 710
Set to change time interval between credit checks. If your credit drops under
defined value, 2N® SmartGate sends SMS "LOW CREDIT". The "0" setting
means that the function is disabled.
Setting options: 0-255 h
Step: 1 h
Default setting: 0
Code for credit checking Function No.: 711
Credit in prepaid SIM cards is checked by network function, which displays text
message on mobile phone display. Code of network function must be terminated
with "#" symbol.
ATTENTION - find out if you have to pay for this function. Every check can lower
your credit.
Setting options: 0-8 characters (0-9,*,#,+)
Default setting: blank
Minimal credit Function No.: 712
Set minimal credit value to send warning SMS "LOW CREDIT". If credit is lower
then given value, warning SMS is send after every credit check, until you
recharge your SIM card.
Setting options: 0-999
Step: 1
Default setting: 0
Credit value position in received SMS Function No.: 713
If there are more numbers except credit value in text answer (e.g. date, time
and so on) 2N® SmartGate seeks the number corresponding with credit value
from given position in text. The seek algorithm skips every non-number
character. If credit value is the first number in text you can leave setting 0. If
there are other numbers before credit value, set parameter to text position, from
which the algorithm will seek.
Setting options: 0-180
Step: 1
Default setting: 0