2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 42)

Table of Parameters 3.2
42
End with # Function No.: 394
This parameter enables to establish the call when a # is received. The #
character is removed from the dialed number. If a # should be part of the dialed
number, this function cannot be used for the given prefix.
Setting options: YES(1)/NO(0)
Default setting: NO
Remove Function No.: 395
The Remove parameter is used for automatic call routing. A defined count of
digits (prefix) is removed from the number beginning.
Setting options: 0-20
Setting step: 1
Default setting: 0
Add Function No.: 396
The Add parameter is used for automatic call routing. A defined string (prefix) is
added to the beginning of the number to be dialed.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
Extra tariff Function No.: 397
Pseudo tariff metering setting (tariff is based on call duration) for GSM calls.
Connected PBX must send tariff metering pulses for FXO calls. The Extra tariff
parameter defines transmitting of fixed quantity of tariff pulses after call start.
This parameter sets minimal call cost.
Setting options: 0-255
Setting step: 1
Default setting: 0
Tariff [s] Function No.: 398
Pseudo tariff metering setting (tariff is based on call duration) for GSM calls.
Connected PBX must send tariff metering pulses for FXO calls. The Tariff
parameter sets the call cost according to call duration. Set how often in seconds
do you want to transmit pulses. Smaller number means more expansive call. 0
means not to transmit pulses according to call duration.
Setting options: 0-255 s
Setting step: 1 s
Default setting: 0 sFAX/DATA routing parameters
Time limit [min] Function No.: 399
After time elapsing is call connection terminated immediately. You can hear beep
30s before end of call. 10s before end you can hear beep every second. The "0"
setting means that the function is disabled.
Setting options: 0-255 min
Setting step: 1 min
Default setting: 0 min