2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 43)

Table of Parameters 3.2
43
Bank No.
Special option for gateways with Free minutes option support. This option is for
gateways with FW version 1.5x and 3.5x only and it is described in separate part
of manual.
FXO routing table parameters
All parameters related to the dialed number and call routing are arranged in three
routing tables. Each table pertains to one interface: FXS, FXO and GSM.
Calls from FXO interface are routed according to “FXO calls rote to” parameter. You
can set 2N® SmartGate as DialThru gateway or as gateway for extension line of PBX.
You can program ME function for the DialThru gateway.
For gateway for extension line of PBX you can fill in the FXO routing table. According
to the prefix of dialed number on FXO interface you can:
 Bar the number to be dialed – 2N® SmartGate hangs up, the call isn‟t
established;
 Accelerate connection establishing by knowing the number length for the given
prefix;
 Accelerate connection establishing by allowing to terminate dialing with a #;
 Modify the number to be dialed by removing and/or adding prefix.
The principle of table function is the same as in the FXS routing table. The call is
controlled according to parameters on the row with dialed number prefix match.
Remember to fill in the "Other prefixes" line for a number whose prefix is not found in
the table.
FXO calls route to Function No.: 400
The main parameter for FXO calls routing. You can program 2N® SmartGate as
DialThru gateway, or as gateway for extension line of PBX.
DialThru gateway: Incoming ringing is immediately connected to FXS
interface. If function ME set, 2N® SmartGate starts to establish GSM call to ME
number after defined number of rings. Routing table FXO is not active.
Gateway for extension line of PBX: 2N® SmartGate detects incoming
ringing and Off-Hook the line after programmed number of rings, if it is possible
to make call to GSM. 2N® SmartGate generate dial tone and after dialing takes
an action according to FXO routing table.
Setting options: FXS - DialThru gateway (0)
GSM - gateway for extension line of PBX (1)
Default setting: FXS - DialThru gateway
Mobility Extension number Function No.: 401
If you program 2N® SmartGate as DialThru gateway, fill in telephone number
for ME function. 2N® SmartGate starts to establish GSM call to ME number after
defined number of rings. Then you can receive incoming FXO call on telephone
line or in GSM network. Blank parameter disables ME function.