2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 48)

Table of Parameters 3.2
48
+420 any setting
603198222 4, or more
603 4, or more
Setting options: 0-15
Step: 1
Default setting: 0
Route to Function No.: 591
It is possible to route incoming GSM call to FXS or FXO interface, or reject it.
When the call is routed to FXS port you can use the CallBack feature. For correct
functionality please set up "Max. ring time for Callback" parameter.
Setting options: FXS -incoming call is routed to FXS
FXO -incoming call is routed to FXO
FXS CallBack -incoming call is routed to FXS with
CallBack functionality
reject -incoming call is rejected
Default setting: FXS
Dial in Function No.: 592
Parameter "Dial in" is used for automatic connection to switchboard operator, or
directly to other subscriber. If this parameter is blank, calling person has
telephone line fully at disposal and has to dial the subscriber number by DTMF.
You can fill only # character to disable Integra function.
Setting options: 0-16 characters (0-9,*,#)
Default setting: blank
Time limit [min] Function No.: 599
After time elapsing is call connection terminated immediately. You can hear beep
30s before end of call. 10s before end you can hear beep every second. The "0"
setting means that the function is disabled.
Setting options: 0-255 min
Setting step: 1 min
Default setting: 0 min
SMS Sending Input Parameters
Telephone number for SMS Function No.:600
The telephone number to which an SMS is sent upon SMS input activation. If
blank, the function is off.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
SMS text Function No.: -
The SMS text to be sent to the preset telephone number. If the SMS text is
blank, SMS with signal strength is sent.
Setting options: 0-40 characters
Default setting: blank