Barco R9002328 - Manual (Page 110)

R5975059A BARCOVISION 708 200498
SERVICE MODE
SERVICE
MODE
R5975059A BARCOVISION 708 200498
SERVICE MODE
SERVICE
MODE
9-5 9-5
The 'Identification' screen gives infor-
mation concerning :
- Projector address. To change the
address of your projector, contact
a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or compat-
ible) or MAC. The baud rate of the projector must be the same as the baud rate
of the connected computer. When there is a difference, contact a qualified
service technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be
displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number can
be useful when calling for technical assistance.
Total Run Time
Highlight 'Total Run Time' with the
control disc and press ENTER to dis-
play the amount of time the projector
has played since its first start up at
the factory.
ENTER gives the selected item.
EXIT returns to the Service mode menu.
ADJUST returns to the Operational mode.
V 708
Proj address : 001
Soft. Version : 5.00
Config. : Ceiling
front
Bruadrate PC : 9600
Text : ON
Serial No. : 10359852
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Select with ê or é
then <ENTER>
<EXIT> to return.
The 'Identification' screen gives infor-
mation concerning :
- Projector address. To change the
address of your projector, contact
a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or compat-
ible) or MAC. The baud rate of the projector must be the same as the baud rate
of the connected computer. When there is a difference, contact a qualified
service technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be
displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number can
be useful when calling for technical assistance.
Total Run Time
Highlight 'Total Run Time' with the
control disc and press ENTER to dis-
play the amount of time the projector
has played since its first start up at
the factory.
ENTER gives the selected item.
EXIT returns to the Service mode menu.
ADJUST returns to the Operational mode.
V 708
Proj address : 001
Soft. Version : 5.00
Config. : Ceiling
front
Bruadrate PC : 9600
Text : ON
Serial No. : 10359852
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Select with ê or é
then <ENTER>
<EXIT> to return.