Barco R9002328 User Manual
Page 130
R5975059A BARCOVISION 708 200498
MESSAGES, WARNINGS AND FAILURES
MESSAGES,
WARNINGS
AND
FAILURES
R5975059A BARCOVISION 708 200498
MESSAGES, WARNINGS AND FAILURES
10-3
10-3
MESSAGES,
WARNINGS
AND
FAILURES
WARNING :
source not
available
The input is a valid input but the source is not connected
to the input terminals or the input source is switched
off.
WARNING :
invalid
key entry
When a wrong key is pressed on the RCU.
WARNING :
invalid
code entry
WARNING :
end of ad-
just range
End of adjustment range.
Message when the entered password is wrong.
WARNING :
input no
longer
available
Message will be displayed when the input source is no
longer available. The following message then appears:
'check input signal or select new source'.
check in-
put signal
or select
new source
Message will be displayed after the message 'input no
longer available'. It asks to check the connections
between the source and the projector or to check if the
source is switched on.
WARNING :
input se-
lector not
available
It warns you to check the power connection or the
power status of the RCVDS.
Next message will appear immediately on the screen
: 'go to stand-by'.
WARNING :
source not
available
The input is a valid input but the source is not connected
to the input terminals or the input source is switched
off.
WARNING :
invalid
key entry
When a wrong key is pressed on the RCU.
WARNING :
invalid
code entry
WARNING :
end of ad-
just range
End of adjustment range.
Message when the entered password is wrong.
WARNING :
input no
longer
available
Message will be displayed when the input source is no
longer available. The following message then appears:
'check input signal or select new source'.
check in-
put signal
or select
new source
Message will be displayed after the message 'input no
longer available'. It asks to check the connections
between the source and the projector or to check if the
source is switched on.
WARNING :
input se-
lector not
available
It warns you to check the power connection or the
power status of the RCVDS.
Next message will appear immediately on the screen
: 'go to stand-by'.