Barco R9002328 - Manual (Page 113)

SERVICE MODE
R5975059A BARCOVISION 708 200498
SERVICE
MODE
SERVICE MODE
R5975059A BARCOVISION 708 200498
SERVICE
MODE
9-8 9-8
Select with ê or é
then <ENTER>
<EXIT> to return.
Change Projector Address
Every projector requires an individual
address between O and 255. This
address can be software installed.
To change that address, push the
control disc up or down to highlight
'Change Projectors Address' and
press ENTER. The Change Projector
Address menu will be displayed and
the actual address will be filled in.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
ENTER displays the 'Change Projector
Address' menu.
EXIT returns to the Service mode main
menu.
The first digit is highlighted. Select the
individual digits by pushing the con-
trol disc to the right or to the left.
Reprogram with the digit keys on the
RCU.
Press ENTER to confirm.
Press EXIT to return to the projector
set up menu.
<ENTER> to confirm
<EXIT> to return.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use ç and è to select,
and reprogram
with numeric keys.
Highest address is 255
Change baudrate
The communication speed between
projector and computer has 8 pos-
sible speeds. The baud rate speed
can be software set up.
Highlight 'Change Baudrate' by push-
ing the control disc up or down and
press ENTER to display the Baud
rate menu.
Select with ê or é
then <ENTER>
<EXIT> to return.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Select with ê or é
then <ENTER>
<EXIT> to return.
Change Projector Address
Every projector requires an individual
address between O and 255. This
address can be software installed.
To change that address, push the
control disc up or down to highlight
'Change Projectors Address' and
press ENTER. The Change Projector
Address menu will be displayed and
the actual address will be filled in.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
ENTER displays the 'Change Projector
Address' menu.
EXIT returns to the Service mode main
menu.
The first digit is highlighted. Select the
individual digits by pushing the con-
trol disc to the right or to the left.
Reprogram with the digit keys on the
RCU.
Press ENTER to confirm.
Press EXIT to return to the projector
set up menu.
<ENTER> to confirm
<EXIT> to return.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use ç and è to select,
and reprogram
with numeric keys.
Highest address is 255
Change baudrate
The communication speed between
projector and computer has 8 pos-
sible speeds. The baud rate speed
can be software set up.
Highlight 'Change Baudrate' by push-
ing the control disc up or down and
press ENTER to display the Baud
rate menu.
Select with ê or é
then <ENTER>
<EXIT> to return.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO