Barco R9002328 - Manual (Page 131)

MESSAGES, WARNINGS AND FAILURES
R5975059A BARCOVISION 708 200498
MESSAGES, WARNINGS AND FAILURES
R5975059A BARCOVISION 708 200498 10-4
MESSAGES,
WARNINGS
AND
FAILURES
10-4
MESSAGES,
WARNINGS
AND
FAILURES
WARNING :
go to
stand by
Projector will switch to 'stand-by' when the RCVDS is
no longer available.
WARNING :
invalid
frequency
input
The entered frequency or applied frequency of the
source is out of the projector's range.
table is
deleted
Message to inform that selected table is deleted. This
message will be followed by 'confirm message', on
which the user has to answer.
FAILURE
I²C error
addr. : 7FH3
Hardware failure. Call a qualified service technician for
repair.
FAILURE
short
circuit on
I²C bus
Hardware failure. Call a qualified service technician for
repair.
FAILURE
RCVDS com-
munication
error
Serial communication error between the RCVDS and
the projector.
FAILURE
IRIS commu-
nication
error
Communication error between IRIS 800 and the projec-
tor. Call a qualified service technician.
WAIT
starting
up
IRIS
Message during the start up of the IRIS 800. Message
will disappear when the IRIS 800 is ready to accept
commands.
WARNING :
go to
stand by
Projector will switch to 'stand-by' when the RCVDS is
no longer available.
WARNING :
invalid
frequency
input
The entered frequency or applied frequency of the
source is out of the projector's range.
table is
deleted
Message to inform that selected table is deleted. This
message will be followed by 'confirm message', on
which the user has to answer.
FAILURE
I²C error
addr. : 7FH3
Hardware failure. Call a qualified service technician for
repair.
FAILURE
short
circuit on
I²C bus
Hardware failure. Call a qualified service technician for
repair.
FAILURE
RCVDS com-
munication
error
Serial communication error between the RCVDS and
the projector.
FAILURE
IRIS commu-
nication
error
Communication error between IRIS 800 and the projec-
tor. Call a qualified service technician.
WAIT
starting
up
IRIS
Message during the start up of the IRIS 800. Message
will disappear when the IRIS 800 is ready to accept
commands.