Barco R9002328 - Manual (Page 111)

SERVICE MODE
R5975059A BARCOVISION 708 200498
SERVICE
MODE
SERVICE MODE
R5975059A BARCOVISION 708 200498
SERVICE
MODE
9-6 9-6
Select with ê or é
then <ENTER>
<EXIT> to return.
Note : all projectors leave the factory after a burn-in period of approximately 100
hours.
This item is password protected.
Highlight 'Change Password' with the
control disc and press ENTER.
ENTER will display the selected item.
EXIT will return to the Path Selection
main menu.
ADJUST will return to the Operational
mode.
Change password
The current password is displayed.
The new password must consist of 4
digits between 0 and 9. Push the
control disc to the left or to the right to
select the digits to be changed. Use
the numeric keys to enter the new
digits.
Press ENTER to save the new pass-
word. Before saving the new pass-
word, a confirmation screen will be
displayed.
Press EXIT to return to the Projector
Setup menu without saving the new
password.
ENTER displays the Confirmation menu.
EXIT returns to the Service mode with-
out saving the new password.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
PASSWORD
Enter password :
1998
Use ç and è to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
Select with ê or é
then <ENTER>
<EXIT> to return.
Note : all projectors leave the factory after a burn-in period of approximately 100
hours.
This item is password protected.
Highlight 'Change Password' with the
control disc and press ENTER.
ENTER will display the selected item.
EXIT will return to the Path Selection
main menu.
ADJUST will return to the Operational
mode.
Change password
The current password is displayed.
The new password must consist of 4
digits between 0 and 9. Push the
control disc to the left or to the right to
select the digits to be changed. Use
the numeric keys to enter the new
digits.
Press ENTER to save the new pass-
word. Before saving the new pass-
word, a confirmation screen will be
displayed.
Press EXIT to return to the Projector
Setup menu without saving the new
password.
ENTER displays the Confirmation menu.
EXIT returns to the Service mode with-
out saving the new password.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
PASSWORD
Enter password :
1998
Use ç and è to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return