Barco R9002328 - Manual (Page 114)

R5975059A BARCOVISION 708 200498
SERVICE MODE
SERVICE
MODE
R5975059A BARCOVISION 708 200498
SERVICE MODE
SERVICE
MODE
9-9 9-9
Select with ê or é
then <ENTER>
<EXIT> to return.
The following baud rates are avail-
able :
-9600
-4800
- 2400
- 1200
- 600
- 300
- 150
- 110
The actual baud rate will be high-
lighted. To change the baud rate,
push the control disc up or down or
to the left or to the right to select the
desired baud rate and press EN-
TER to accept this baud rate.
<ENTER> to accept
<EXIT> to return.
BAUDRATE
Select new
baudrate :
9600 4800
2400 1200
600 300
150 110
Select with arrow
keys ;
ENTER to accept the selected baud
rate.
EXIT to return without changing the
baud rate.
Power up mode
When pressing the power switch,
the projector can start up in 'oper-
ating mode' or in 'stand-by mode'.
Operating mode : the projector start
up and displays image .
Stand-by mode : the projector start
up in stand-by and waits until the
stand-by button or a digit key is
pressed.
To change the Power up mode,
select Power Up mode by pushing
the control disc up or down and
press ENTER to toggle between
'Operating' and 'Stand-by'.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
ENTER to toggle between operating and
stand-by.
EXIT to return to the Service menu.
Select with ê or é
then <ENTER>
<EXIT> to return.
The following baud rates are avail-
able :
-9600
-4800
- 2400
- 1200
- 600
- 300
- 150
- 110
The actual baud rate will be high-
lighted. To change the baud rate,
push the control disc up or down or
to the left or to the right to select the
desired baud rate and press EN-
TER to accept this baud rate.
<ENTER> to accept
<EXIT> to return.
BAUDRATE
Select new
baudrate :
9600 4800
2400 1200
600 300
150 110
Select with arrow
keys ;
ENTER to accept the selected baud
rate.
EXIT to return without changing the
baud rate.
Power up mode
When pressing the power switch,
the projector can start up in 'oper-
ating mode' or in 'stand-by mode'.
Operating mode : the projector start
up and displays image .
Stand-by mode : the projector start
up in stand-by and waits until the
stand-by button or a digit key is
pressed.
To change the Power up mode,
select Power Up mode by pushing
the control disc up or down and
press ENTER to toggle between
'Operating' and 'Stand-by'.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
ENTER to toggle between operating and
stand-by.
EXIT to return to the Service menu.