Kinze Grain Carts Rev. 7/14 - Manual (Page 20)

M0238-01 Grain Cart
2-6 5/12
TM
Operation
PTO TORqUE LIMITING/OVERRUNNING CLUTCH PROTECTION
The torque limiting clutch disengages if auger becomes obstructed to prevent driveline and gearbox damage.The torque
limiting clutch resets automatically when PTO RPM is reduced.
The overrunning clutch allows auger system to freewheel and protects tractor and cart from shock damage withPTO
brake-equipped tractors.
Torque limiting clutch
Overrunning clutch
BELT ENGAGEMENT INDICATOR
An indicator pointer on front side of belt housing shows if
horizontal auger is engaged (ON) or disengaged (OFF).
indicator should be OFF when PTO is engaged to reduce start up
torque requirements.
As belt tension is disengaged (OFF) you will hear linkage snap
over center and release belt tension.
HYDRAULIC FLOW GATE
Hydraulic flow gate controls volume of grain to horizontal auger.
An indicator on front panel shows position of flow gate.
1. Engage PTO for the vertical auger at low RPM.
2. Engage belt drive clutch to start the horizontal auger.
3. Open gate half way.
4. Adjust flow gate to desired unloading rate.
NOTE: Recommended initial flow gate position for rice is half open.
Belt engagement indicator
Flow gate position indicator