Driveline inspection, Driveline inspection -18 – Kinze Grain Carts Rev. 7/14 User Manual
Lubrication and Maintenance
after first 20 loads, at beginning of each season, and after every 150 loads or annually thereafter.
Remove inspection cover and proceed as follows:
Make a general inspection of driveline looking for loose hardware.
Inspect belt alignment and tension. See “V-Belt Tension Adjustment And Alignment” in the Maintenance section of
Inspect the three cap screws in each belt pulley bushing and tighten evenly to torque specifications.
Inspect pulley drive keys making sure they are properly located and tight.
Inspect all grease hoses for damage and proper routing.
Lubricate all grease fittings. See Lubrication section of this manual.
Check gearbox oil level.
Inspect bearings and seals in gearbox.
Inspect PTO attaching hardware and safety shields.
Repair or replace worn or damaged parts.