Kinze Grain Carts Rev. 7/14 - Manual (Page 22)

M0238-01 Grain Cart
2-8 5/12
TM
Operation
GRAIN TANK CLEAN OUT SWEEP
DANGER!
Never use clean out sweep while PTO and/or augers are running.
DANGER!
Never remove dump door while PTO and/or augers are running.
DANGER!
Never work around PTO, gearbox or belt drive system or allow anyone
else to do so while PTO is running.
To access the grain tank clean out sweep, remove the cap nut and heavy washer at the bottom of the rear inspection cover.
Remove the cap screws that secures clean out sweep and remove the covers and dump door(s) on the underside of the
grain tank. Set hardware aside.
Remove the auger inspection cover at the front of the wagon by removing nuts.
Remove the wing nuts holding the rod storage cover plate and remove the two lengths of extension rods. Connect the
two extension rods together and attach to the clean out sweep.
Attach extension rods and pull the clean out sweep as far back as possible then push it as far forward as possible.
Repeat this procedure several times. Inspect the inside of the wagon to ensure clean out is complete.
Reinstall auger inspection covers and dump door(s) at front of wagon and dump door on underside of grain tank at rear
of wagon. Store clean out sweep extension rods and reinstall and tighten all hardware.
Cap Nut And Washer
Rear Inspection Cover
Rod Storage Cover Plate