Kinze Grain Carts Rev. 7/14 - Manual (Page 51)

TM
Grain Cart M0238-01
5/12 3-15
Lubrication and Maintenance
Pulleys must be aligned with the fixed idler position.
Clearance of 22⁄3" must be maintained between rear of belt
pulleys and idler.
1. Tighten taper-lock bushing hardware.
2. Lay a straight edge across face of the drive and driven
belt pulleys to ensure alignment between the grooves
on the belts and pulleys and between the idler.
NOTE: Pulleys do not need to be loosened to remove/
replace V-belts.
NOTE: V-belts should be replaced as a matched pair.
See “V-Belt Replacement”.
Lay Straight Edge Across Face Of
Drive And Driven Belt Pulleys
22⁄3"
V-BELT ALIGNMENT
14. Check and adjust belt tension.
NOTE: Do not use belt dressing on V-belts. Keep all oil and grease off V-belts and belt pulleys. Drive and
driven sheaves (pulleys) do not need to be loosened to remove/replace V-belts. Low belt tension will reduce
V-belt life.
15. Install all covers removed in previous steps before operating cart. Cycle hydraulic cylinder engaged in STEP 6,
between extended and retracted positions to check proper engagement/disengagement of belt tension idler.
2¾"