Kinze Grain Carts Rev. 7/14 - Manual (Page 47)

TM
Grain Cart M0238-01
5/12 3-11
Lubrication and Maintenance
Wheels are attached to hubs with ten press fit studs through hub flanges and wheel nuts. Clean threads with a wire
brush and oil lightly to retard corrosion when removing and installating wheels.
Torque wheel nuts to 350 ft. lbs. and retorque daily during first 3 days of use and weekly thereafter.
NOTE: On tracked machines equipped with cast iron segmented end wheels, torque hardware which attaches
the segments to hubs to 220 ft. lbs.
Check tire pressure before each use. Minimum/Maximum
66/43.00-25 (20 Ply) R-1 (900 Cart) 35 PSI/40 PSI (241 kPa/275 kPa)
1100/45 R46 189 A8 (1100/1300 Flotation Cart) 51 PSI/56 PSI (352 kPa/386 kPa)
520/85 R42 165 A8/B (1100/1300 Row Crop Cart) 42 PSI/47 PSI (290 kPa/324kPa)
10 Bolt Hub Shown
WHEEL NUTS
TIRE SERVICING
WARNING
Explosive separation of rim and tire parts can result in death or serious
injury. Rim and tire servicing, improper use of rims and tires, or worn or
improperly maintained tires can cause tire explosion.
To prevent tire explosions:
• Maintain proper tire pressure. Inflating a tire above or below the recommended pressure can cause tire damage.
• Mount tires only by properly trained personnel using proper equipment.
• Replace tires with cuts or bubbles. Replace damaged rims. Replace missing lug bolts and nuts.
• Do not weld or heat wheel assembly. Heating increases tire pressure.
INFLATION SPECIFICATIONS
WARNING
Over-inflation of tires can result in explosive separation of rim and tire
and cause death or serious injury. Different size rims are designed for
different tire pressures. Inflate to correct pressure for specific rim size.
Soft Track Assembly
Hardware That
Attaches Segments