Kinze Grain Carts Rev. 7/14 - Manual (Page 26)

M0238-01 Grain Cart
2-12 5/12
TM
Operation
6. Press the Open/On button on the fi rst transmitter being introduced. The receiver will beep after receiving the
transmitter signal.
7. Repeat step 6 for any remaining transmitters.
8. The receiver will expect fi ve signals, so if you are programming less than fi ve transmitters, press the Open/On
button additional times on the last transmitter you are programming. Push the Open/On button a total of five times
(see programming example).
9. After pushing the Open/On button five times, the receiver will beep twice to indicate that it has been programmed
successfully.
10. Verify that each transmitter is operating correctly. If none of the transmitters are operating correctly, verify that there
are 12 to 14 volts from the receiver positive to negative, then repeat steps 3 to 9.
11. Refasten receiver cover.
Receiver programming example:
In this example, the receiver controls the 3500 motor. The task is to program the receiver to recognize three
transmitters.
1. Remove the receiver cover and turn on the three transmitters.
2. Set all three transmitters to the tarp system channel.
3. Press and hold the programming button on the RF solenoid for five seconds. The solenoid will beep to indicate it
has entered Channel Programming Mode. Release the programming button.
4. Press the Open/On button on the first transmitter. The receiver will beep to indicate that it has received a signal and
memory slot #1 has been filled.
5. Press the Open/On button on the second transmitter. The receiver will beep to indicate that is has received a signal
and memory slot #2 has been filled.
6. Press the Open/On button on the third transmitter. The receiver will beep to indicate that it has received a signal and
memory slot #3 has been filled.
7. Press the Open/On button on the third transmitter again. The receiver will beep to indicate that it has received a
signal and memory slot #4 has been filled.
8. Press the Open/On button on the third transmitter again. The receiver will beep twice to indicate that it has received
a signal, and memory slot #5 has been filled. The double beep also indicates that the receiver has exited programming
mode.
9. Verify that the tarp system Open and Close operations are functioning correctly on all three transmitters.
10. Refasten the receiver cover to motor assembly.