Lenze E84AYCEC - Manual (Page 9)

EDS84AYCEC EN 3.0 - 09/2012
L
9
E84AYCEC communication manual (Ethernet POWERLINK)
About this documentation
Terminology used
1.3 Terminology used
Term Meaning
Controller Lenze controllers of the "Inverter Drives 8400" series
Standard device
»Engineer«
Lenze PC software which supports you in "engineering" (parameterisation,
diagnostics and configuration) throughout the whole life cycle, i.e. from
planning to maintenance of the commissioned machine.
Code Parameter used for controller parameter setting or monitoring. The term is
usually called "index".
Subcode If a code contains more than one parameter, these parameters are stored in so-
called "subcodes".
In this documentation a slash "/" is used as a separator between code and
subcode (e.g. "C00118/3").
The term is usually called "subindex".
Lenze setting This setting is the default factory setting of the device.
Basic setting
HW
Hardware
SW Software
EPL Abbreviation for "Ethernet POWERLINK"
(EPL) nodes Ethernet POWERLINK nodes (Managing Node, Controlled Nodes)
CN Controlled node (EPL slave)
MN Managing node (EPL master)
The Managing Node accepts the control function for the data communication of
the decentralised field devices. Typically, the Managing Node is the
communication interface of a PLC.
Node ID EPL node address