C14886 | set ext. diagnostic bit upon, C14887 | suppress signalling diag. mess. upon, 14 parameter reference – Lenze E94AYCPM User Manual
Page 108
14
Parameter reference
14.3
Parameters of the communication module for slot MXI2
108
Lenze · E94AYCPM communication module (PROFIBUS®) · Communication Manual · DMS 12.0 EN · 11/2012 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C14886
C14887
Parameter | Name:
C14886 | Set ext. diagnostic bit upon
Data type: BITFIELD_8
Index: 9689
d
= 25D9
h
Bit-coded selection of the error responses in the standard device causing the external diagnostic bit ("diag bit") to
be set (see PROFIBUS specification; bit 3 of byte 1 of the DP diagnostic messages).
• The diagnostic bit is sent to the PROFIBUS master where it is evaluated separately.
• The diagnostic bit is always set when a system error occurs.
• The Lenze setting "0" means that the diagnostic bit is not set for the following error responses.
• An advanced diagnostic message is always sent.
Value is bit-coded:
Bit 0 Error
Bit 1 Trouble
Bit 2 Quick stop by trouble
Bit 3 Warning locked
Bit 4 Warning
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
;
Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
Parameter | Name:
C14887 | Suppress signalling diag. mess. upon
Data type: BITFIELD_8
Index: 9688
d
= 25D8
h
Available from software version 01.20!
Selection of the error responses not causing a diagnostic request to the PROFIBUS master.
A diagnostic request is always signalled if a system error or an error message from the SM301 (E94AYAE) safety
module occurs.
The Lenze setting "0" means that for each of the following error responses a diagnostic request is signalled.
Value is bit-coded:
Info
Bit 0 Error
Bit 1 Trouble
Bit 2 Quick stop by trouble
Bit 3 Warning locked
Bit 4 Warning
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Error message
Available from software version 01.21!
Selective suppression of the error message "Available
connection to 9400 standard device lost"
;
Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT