Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 106)

106 Publication 1404-UM001F-EN-P - November 2009
Chapter 4 Communication
EtherNet/IP (CIP) Protocol
Allen-Bradley controllers since the release of the ControlLogix
platform have used the EtherNet/IP or CIP protocol. In particular,
PLC-5 and SLC 5/05 controllers at or later than the following series
and revision levels support CIP communication:
•
PLC-5/xxE Series C/ Rev. N
•
PLC-5/xxE Series D/ Rev. E
•
PLC-5/xxE Series E/ Rev. D
•
SLC 5/05 Series A FRN 5 (OS 501)
•
SLC 5/05 Series C
EtherNet/IP explicit messaging from a PLC-5E or SLC 5/05 controller
to a Powermonitor 3000 unit uses a MultiHop message path. The
client controller thinks it is communicating with a ControlLogix
controller. The example message detail screens below indicate a
PLC/5xxE reading the voltage and current table F15:0 from a power
monitor to the controller’s F15:0 data table.
PLC-5/xxE Controller Message Detail Screen Example