Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 47)

Publication 1404-UM001F-EN-P - November 2009 47
Powermonitor 3000 Unit Operations Chapter 3
Configuration by Using the
Display Module The display module provides an inexpensive, easy-to-operate method
for setting up power monitor parameters to adapt it to your power
system and select the performance options you desire. You configure
the power monitor by using Program mode and Edit mode of the
display module.
You may also configure the power monitor via communication, and
certain advanced features of the power monitor may be configured
only via communication.
Please refer to the appropriate sections of the user manual for more
information.
Commands
Parameter Description Range
Force Relay Forces relay to a known state in which the relay
remains at that state until the force is removed. De-energize
Energize
No Force
Force KYZ Forces KYZ to a known state in which the relay
remains at that state until the force is removed. De-energize
Energize
No Force
Clear Min/Max Log Resets the Min/Max log with the current real
time metering information. Yes
No
Clear kWh Counter Resets the kWh net counter to zero. Yes
No
Clear kVARh Counter Resets the kVARh net counter to zero. Yes
No
Clear kVAh Counter Resets the kVAh net counter to zero. Yes
No
Clear Ah Counter Resets the Ah net counter to zero. Yes
No
Clear All Energy Counters Resets all cumulative energy counter to zero. Yes
No
Clear S1 Counter Resets Status 1 counter to zero. Yes
No
Clear S2 Counter Resets Status 2 counter to zero. Yes
No
Restore Defaults Settings Restores all settings to factory default. Yes
No
Clear Setpoint Timers Clears the time accumulated in each setpoint
timer. Yes
No