Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 130)

130 Publication 1404-UM001F-EN-P - November 2009
Chapter 5 Setpoint Programming and Operation
24 Crest factor I4 Amps
• • •
25
IEEE THD voltage
(1) Volts
• • •
26
IEEE THD current
(1) Amps
• • •
27 IEEE THD I4 Amps
• • •
28
IEC THD voltage
(1) Volts
• • •
29
IEC THD current
(1) Amps
• • •
30 IEC THD I4 Amps
• • •
31 Status input 1 -
• • •
32 Status input 2
• • •
33
Any status input
(1)
• • •
34 Setpoint #1 time accumulator Seconds
• • •
35 Setpoint #2 time accumulator
• • •
36 Setpoint #3 time accumulator
• • •
37 Setpoint #4 time accumulator
• • •
38 Setpoint #5 time accumulator
• • •
39 Setpoint #6 time accumulator
• • •
40 Setpoint #7 time accumulator
• • •
41 Setpoint #8 time accumulator
• • •
42 Setpoint #9 time accumulator
• • •
43 Setpoint #10 time accumulator
• • •
44
Voltage Sag
(1) (2) Volts
• •
45
Voltage Swell
(1) (2)
• •
46
Transient detected
(2) -
•
47 Avg IEEE THD V %
• • •
48 Avg IEEE THD I
• • •
49 Avg IEC THD V
• • •
50 Avg IEC THD I
• • •
51 Avg Crest Factor V -
• • •
52 Avg Crest Factor I
• • •
(1)
A setpoint activates when the magnitude of any phase passes the activation limit and releases when all
phases pass the release limit in the appropriate direction for the setpoint evaluation condition.
(2) These setpoint types apply only to the applicable Powermonitor 3000 models and will appear as inactive on
other models.
Setpoint Types
Setpoint Type Description Units M4,
M5 M6 M8