Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 46)

46 Publication 1404-UM001F-EN-P - November 2009
Chapter 3 Powermonitor 3000 Unit Operations
3. Choose the option of the command by pressing the Up Arrow
and Down Arrow keys until the desired option is displayed.
Notice the phase indicators on the right-hand side remain solid
and the command option being selected is still flashing.
Command Option
4. After the desired command option is displayed, press the Enter
key to execute the command.
The selection prompt reappears and the display module is set
back to Program mode. Notice the phase indicators on the
right-hand side are flashing again and the option prompt is now
solid.
Program Mode
To abort a command, press the Escape key. The display module
returns to Program mode and the option prompt is displayed
again. Notice the phase indicators on the right-hand side are
now flashing and the option prompt is now solid.
LAY - 1
Energ
L1
L2
L3
N
Powermonitor 3000
FORCE
UP-DN
L1
L2
L3
N
Powermonitor 3000