Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 281)

Publication 1404-UM001F-EN-P - November 2009 281
Appendix
C
Sample Applications
Introduction This appendix contains sample applications including ladder diagrams
to help you get started in setting up communication between your
application and a power monitor.
The application samples depict basic methods for reading and writing
data between a power monitor and your programmable controller or
other application. Expand on these basic steps to customize your
application to meet your business needs. The sample applications
include the following:
•
Read and write the power monitor system clock by using a
variety of controllers, applications and communication networks.
•
Read multiple power monitor data tables into an SLC 500
controller by using a DeviceNet communication network.
•
Set up the user-configured data table by using a ControlLogix
controller and an EtherNet/IP communication network.
•
Read and write power monitor tables by using an SLC 500
controller and a 1747-SCNR ControlNet scanner.
•
Read and write power monitor tables by using a MicroLogix
controller over EtherNet/IP and Modbus RTU communication
networks.
•
Read and write power monitor tables by using a Component
HMI over an EtherNet/IP communication network.
ATTENTION
Proper operation of the application is your responsibility. Rockwell
Automation makes no warranty, express or implied, for these sample
applications. The sample applications are subject to change at any
time without notice.