Rockwell Automation 1203-CN1 ControlNet Communications Module 1203-CN1 - Manual (Page 26)

Publication 1203-5.13 – February, 2002
2-6 Installation
5. Connect the SCANport cable to the SCANport product and the
module.
To connect the cable to the module, align the pins on the cable
with the holes in the SCANport connection and then insert the
SCANport cable. The cable will click into a locked position.
Figure 2.4
Connecting the SCANport Cable to the Module
6. Connect the ControlNet cable tap(s) to the ControlNet media and
the module.
To connect the cable tap(s) to the module, twist each onto the
ControlNet Coax connection(s). You will hear the tap(s) click
into a locked position.
Important: Make sure you connect the Channel A cable to the
Channel A connection and the Channel B cable to the Channel B
connection.
Figure 2.5
Connecting a Straight ControlNet Tap to the Module