Rockwell Automation 1203-CN1 ControlNet Communications Module 1203-CN1 - Manual (Page 51)

Publication 1203-5.13 – February, 2002
Configuring a Controller to Communicate with the 1203-CN1 Module 4-7
3. Select the line with the SCANport product you want to configure.
Important: You can verify that you’ve selected the correct line by
making sure it has the same node number that you set for the module
during the installation.
4. In the Insert menu, select Device Connection.
Figure 4.7
Example of the Product Line after Drive Connection Is Selected
5. Fill in each of the following fields on the bottom of the screen
with unique, valid N-file numbers for the controller you are using.
(Each N-file number must be unique.)
• Diagnostics
• Status
• Configuration
• Data Input
• Data Output
6. Note the N-file numbers you filled in the fields. You will need
them to develop a ladder logic program.