Rockwell Automation 1203-CN1 ControlNet Communications Module 1203-CN1 - Manual (Page 35)

Publication 1203-5.13 – February, 2002
Getting Started 3-7
16. Press the Enter key. The main menu of the1203-CN1 ControlNet
to SCANport Adapter application appears.
Figure 3.8
Main Menu
You now have access to the module’s software. Go to the Navigation
Techniques section on page 3-8 for more information on using it.
Using a VT100-Compatible Terminal
Important: If you are using a PC, skip this section.
The following instructions describe how to establish a serial
connection to the module using a VT100-compatible terminal.
1. Connect a 1203-SFC serial cable to your terminal and then to the
RS-232 serial port on the module. Refer to Figure 3.1.
2. Start your terminal.
3. Select the following settings:
• 9600 in the Bits per second field.
If you have previously set the module’s Serial Port Rate
(Parameter 21) to enable 19200 bps, set the bps to 19200.
• 8 in the Data bits field.
• None in the Parity field.
• 1 in the Stop bits field.
• None in the Flow Control field.