Rockwell Automation 1203-CN1 ControlNet Communications Module 1203-CN1 - Manual (Page 53)

Publication 1203-5.13 – February, 2002
Configuring a Controller to Communicate with the 1203-CN1 Module 4-9
10. In the Configuration menu, select Auto Map and then All
Entries. Addresses are put in the Input Address and Output
Address columns.
Figure 4.9
Example Configuration
Important: If you want to map the addresses manually, click in the
correct field and then enter the address. Make sure you insert a valid
address. Refer to the online help for information on manually
mapping an address.