Rockwell Automation 2711PC-xxxx PanelView Plus Compact User Manual - Manual (Page 24)

24 Publication 2711PC-UM001A-EN-P - March 2009
Chapter 3 Connecting Power
Removing and Installing the
Power Terminal Block The terminals are shipped with the power terminal block installed.
You can remove the terminal block for ease of installation, wiring, and
maintenance.
PanelView Plus Compact 400 and 600 Terminals
Follows these steps to remove the terminal block in the PanelView
400 and 600 terminals.
1. Insert the tip of small, flat-blade, screwdriver into the terminal
block access slot.
2. Gently pry the terminal block away from terminal to release the
locking mechanism.
WARNING
Explosion Hazard
Substitution of components may impair suitability for hazardous
locations.
Do not disconnect equipment unless power has been switched
off and area is known to be nonhazardous.
Do not connect or disconnect components unless power has
been switched off.
All wiring must comply with N.E.C. articles 501, 502, 503,
and/or C.E.C. section 18-1J2 as appropriate.
Peripheral equipment must be suitable for the location in which
it is used.
ATTENTION
Do not force terminal blocks into connectors to prevent
potential damage to terminal.