Rockwell Automation 2711PC-xxxx PanelView Plus Compact User Manual - Manual (Page 75)

75 Publication 2711PC-UM001A-EN-P - March 2009 75
Chapter
5
Installing and Replacing Components
Chapter Objectives This chapter shows how to install or replace specific components of
the terminals.
•
Battery
•
Backlight
•
External CompactFlash card
•
Product ID label
•
Display module bezel
Required Tools These tools are required to install and replace components:
•
#00, #1, and #2 Phillips screwdriver
•
Electrostatic Discharge (ESD) wristband
Precautions Before installing or replacing any components, disconnect power
from the terminal. During installation, take care not to touch any of
the exposed electronic components.
WARNING
Disconnect all power from the terminal before installing or
replacing any components. Failure to disconnect power may
result in electrical shock or damage to the terminal.
ATTENTION
Be careful when touching any of the exposed electronic
components to prevent damage from electrostatic discharge
(ESD).
Work in a static free environment and wear a properly
grounded ESD wristband.