Rockwell Automation 2711PC-xxxx PanelView Plus Compact User Manual - Manual (Page 85)

Publication 2711PC-UM001A-EN-P - March 2009 85
Installing and Replacing Components Chapter 5
Follow these steps to replace the display module bezel.
1. Make sure the bezel is free of lint and marks.
2. Attach the touch screen connector.
3. Place the back of the display module over the bezel.
Be careful not to pinch any of the cables. Allow the touch screen
connector to extend out of the access opening.
4. Connect the touch screen connector.
5. Replace the sealing gasket.
6. Attach the screws that secure the display module to the bezel
and tighten to a torque of 1.35…1.58 N•m (12…14 lb•in).
7. Re-attach the small metal plate to the back of the display module
using two screws and torque to 0.58 N•m (5…7 lb•in).
Cleaning the
Display Window Use a protective antiglare overlay for easier cleaning of the display
window.
Follow these steps to clean the display window.
1. Disconnect power from the terminal at the power source.
2. Use a clean sponge or soft cloth with a mild soap or detergent to
clean the display.
3. Dry the display with a chamois or moist cellulose sponge to
avoid water spots.
Remove fresh paint splashes and grease before drying by rubbing
lightly with isopropyl alcohol (70% concentration). Afterward, wash
using a mild soap or detergent. Rinse with clean water.
ATTENTION
Use of abrasive cleaners or solvents may damage the display.
Do not scrub or use brushes.