Rockwell Automation 2711PC-xxxx PanelView Plus Compact User Manual - Manual (Page 29)

Publication 2711PC-UM001A-EN-P - March 2009 29
Connecting Power Chapter 3
Resetting the Terminals Use the reset switch to restart a terminal without having to disconnect
and reapply power. After a reset, the terminal performs a series of
startup tests and then either:
•
runs the .MER application loaded in the terminal.
•
enters Configuration mode.
The action that occurs depends on the startup options configured for
your terminal. Refer to page
60 for information on startup options.
Refer to Chapter 8 , Troubleshooting , for a list of startup information
and error messages.
•
On 400 and 600 terminals, press the reset switch with your
finger or a nonconductive object.
•
On 1000 terminals, insert a thin, nonconductive probe into the
hole marked reset and press the switch.
Reset
Reset Switch
ATTENTION
Use a nonconductive object to press the reset or default switch.
Do not use a conducting object such as a paper clip or you may
damage the terminal. Do not use the tip of a pencil; graphite
may damage the terminal.