Define an ethernet ip address – Rockwell Automation 2711PC-xxxx PanelView Plus Compact User Manual User Manual
Page 42
Advertising
42
Publication 2711PC-UM001A-EN-P - March 2009
Chapter 4 Configuring the Terminal
Define an Ethernet IP Address
Some networks automatically assign IP addresses to Ethernet devices
if DHCP is enabled. If DHCP is not enabled, you can manually enter
an IP address for the terminal.
Follow these steps to view or enter an IP address for your terminal.
1. Select Terminal Settings>Networks and
Communications>Network Connections>Network Adapters.
2. Press the IP Address button to view or modify the IP address.
3. Press the DHCP button to enable or disable DHCP assignment of
addresses.
4. Press the IP address, Subnet Mask, and Gateway buttons, then
enter the appropriate information.
5. Press OK when done.
E100CE1:Built-in Ethernet Controller
Advertising