Rockwell Automation 6000 PowerFlex Medium Voltage Variable Frequency Drive Installation Instructions - Manual (Page 48)

48 Rockwell Automation Publication 6000-IN006A-EN-P - April 2014
Chapter 3 Drive Electrical Installation
Cable access openings are located on the bottom plate of the connection cabinet
identified by the customer specific Dimension Drawing.
Figure 28 - Power Cable Entry Locations in the Isolation Transformer Cabinet
The drive is supplied with the following provisions for power cable lugs.
Figure 29 shows typical connection points for the primary entrance/exit cable.
Connect the three-phase medium voltage inputs L11, L12, and L13 to the user-
provided input three-phase AC power.
Connect three-phase medium voltage inputs U, V, and W to the user-provided
three-phase asynchronous motor.
Cable clamps are provided in the cabinet to aid in routing and supporting the
incoming line and outgoing motor power cables.
Table 10 - Power Terminals
Incoming Line Cable Connections L11 L12 L13
Outgoing Motor Cable Connections U V W
IMPORTANT If an optional Bypass cabinet is supplied, the incoming line and outgoing
motor cable connections are in the Bypass cabinet.
Refer to publication 6000-UM002_-EN-P.
Outgoing Motor Cables
Incoming Line Cables