Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 119)

Terminal Messages B–3
Publication 2706-816
Terminal System Message: Recommended Action Is: Means: Type:
PLC in Program Mode Comm Status PLC is not ready to communicate. Set PLC to Run mode.
Value not in range Reminder The entered value is out of the accept-
able range. Enter a value within the acceptable
range.
When power is first applied to the MessageView terminal or the
terminal is reset, a series of self-tests are performed. The initial
display shows copyright information and the status of the self-test
(test number). As each test is performed, its test number appears.
Self-test Number
Boot Code Version Number
Copyright, 1995
Allen-Bradley Company
V01.00 V01.00
22
Firmware
Version Number
Note: You may not see all of these test numbers during a power-up
or reset. However all tests are performed.
When all the self–tests are completed, the message Self-Tests
Complete is displayed for 2 seconds.
If a test has failed, a message is displayed showing the number of the
failed test. Note the bootcode/firmware version numbers and error
number when calling Allen-Bradley for technical support.
Error
Number
Copyright, 1995
Allen-Bradley Company
V01.00 V01.00
Error #16
See the table below for a description of the self-test numbers, and
what to do if one of the tests fails.
You can also run most of these tests using commands on the Front
Panel Editor. See Page 3–21.
Note: To reset the MessageView terminal, simultaneously press the
up arrow , down arrow , and Enter keys.
Self Test Numbers and
Descriptions