Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 28)

3–5 Front Panel Editor
Publication 2706–816
This menu item allows the terminal operator to view and if necessary
to modify the communication parameters used by the terminal’s
ports.
To select the type of communication:
Select Serial Communication from the FPE menu and press the
Enter key. Depending on the type of MessageView terminal,
one of these two menus will appear:
•
Remote I/O terminals:
Remote I/O
Communication
Auxiliary Device
Communication
•
ASCII Triggering or Slave Device terminals:
Terminal Function
Data Bits
Parity
Stop Bits
Hardware Handshake
Node Address
Baud
Remote I/O communication
The RIO port on the DaughterBoard is connected to a PLC or other
logic controller. Its parameters are set via the application, and are
view-only in the MessageView terminal FPE.
To view Remote I/O parameters:
1. Select Remote I/O Communication and press the Enter key
to display the Remote I/O submenu.
Rack Number
Rack Size
Starting Group
Last Chassis
Block Transfer
Baud
Note: You can display the Remote I/O parameters in order to make
sure the logic controller has the same settings.
Serial Communication