Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 43)

3–20 Front Panel Editor
Publication 2706–816
Display Brightness
The display can be set to different brightness levels. You may prefer
to have a different setting than that set by the application designer.
1. Select Brightness from the Front Panel Editor menu. Press the
Enter key to display the current level of brightness.
Brightness
75%
2. Use the up or down arrow keys to select an available
setting.
Options are 12%, 25%, 38%, 50%, 60%, 75%, 87%, and 100%.
Note: The brightness of the dialog box shows how the display
will appear with the current setting. This helps you decide which
level of brightness will work best.
3. Press the Enter key to save the setting and return to the
Terminal Setup submenu.
Or press the Ack key to return to the Terminal Setup
submenu without saving anything.
4. Press the Ack key to return to the FPE menu.
Flash Rate
A message may have flashing characters, or in some cases the whole
message may flash. You may prefer to have a different flash rate than
that set by the application designer.
1. Select Flash Rate from the Front Panel Editor menu. Press the
Enter key to display the current level of brightness.
Flash Rate
Low