Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 38)

3–15 Front Panel Editor
Publication 2706–816
Debug Mode
In Debug Mode the terminal displays only message numbers as
messages are triggered. Use Debug Mode to assist with
troubleshooting.
Debug mode is either enabled or disabled. The default setting is
downloaded with the application.
To enable or disable Debug Mode:
1. Select Debug Mode from the Terminal Setup submenu. Press the
Enter key to display the current status of Debug Mode.
Debug Mode
Disabled
2. Use the up or down arrow keys to toggle between
Disabled and Enabled. The current setting is displayed as
highlighted text.
3. Press the Enter key to save the option and return to the
Terminal Setup submenu.
Or press the Ack key to return to the Terminal Setup
submenu without changing the option.
4. Press the Ack key to return to the FPE menu.
Note: When Debug Mode is enabled, if a message number is
triggered that is not defined in the application, the terminal will
display an error message which includes the undefined number.