Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 35)

3–12 Front Panel Editor
Publication 2706–816
The Terminal Setup option on the Front Panel Editor (FPE) menu
allows you to select setup options and modes of operation.
To change the Terminal Setup:
1. Select Terminal Setup from the FPE menu and press the Enter
key. The Terminal Setup submenu appears.
Startup Message
Background Message
Debug Mode
Simulate
Enable/Disable
Simulate Parameters
Simulate Mode
Password
Brightness
Flash Rate
2. Use the up or down arrow keys to scroll through the
Terminal Setup options.
3. Press the Enter key to select the highlighted option.
4. Use the up or down arrow keys to toggle between the
options.
5. Press the Enter key to select the displayed option and return
to the Terminal Setup submenu.
Or press the Ack key to return to the Terminal Setup
submenu without changing the option.
6. Press the Ack key to return to the FPE menu.
Terminal Setup